The Submersible Pump:
- Flow Rate: 80 GPH
- Max head: 22″
- Adjustable flow rate (knob Adjustment)
- Power: 2.7W
- Outlet: .5″
- Dimensions: 1.75″ X 1.75″ X 1.25″
Minimal setting recommended
When pump is not in use store submersed in water.
Position the NP=Series Submersible pump on the bottom of the plating cell (PN:800PVC) in a horizontal position. Attach the suction cups to the side of the cell wall at a location that directs the pump discharge toward the opening in the middle cell divider at the end opposite from the heater mounting.
Note: Use water to moisten the suction cups prior to adding plating solution.
Minimum flow is recommended when a test strip is being plated. Adjust the flow control slide to the minimum setting before filling the plating cell with plating solution. It may be necessary to direct the pump flow somewhat away from the lower divider wall opening to control agitation in a manner that does not push the test strip so as to favor one anode over the other.