All You Need
In One Single
Theme.
Lorem ipsum dolor sit amet, consectetuer adipiscing elit, sed diam nonummy nibh euismod tincidunt ut laoreet dolore magna aliquam erat
Search here:

  • No products in the cart.
  • No products in the cart.

Shop

PN: 800L Plating Cell

$310.00

PN: 800L Plating Cell Poly-carbonate (Two Compartment)

SKU: 800L Category:

Description

Cell P/N Lexan PVC Flow Holes Pump Max °F Approx. Volume Lab setting In-tank
785A Yes No Yes No 212 1 Gal. w/ container Yes Yes
785B No Yes Yes No 360 1 Gal. w/ container Yes Yes
785C Yes No No No 212 1/2 Gal. Yes No
800L Yes No No Yes 212 1 Gal. Yes No
800PVC No Yes No No 360 1 Gal. Yes No
492 No Yes Yes No 180 400 Milliliters Yes Yes

The PN:  800L Plating Cell has two compartments and are specifically designed for precision deposit stress measurements and is to be used in a laboratory.  A dividing wall separates the cells into two equal sections.  The dividing wall has flow holes between the two compartments to permit the solution to flow through both sections (Size 8.5″ x 9.25″ x 7.75″). One section is for using the Immersion Heater (PN:3046) and agitation by using the Submersible Pump (PN: 404 *Note: Once the pump is used it is to be stored in water). This cell offers a standard geometry with respect to anode size and positioning.  Consistent anode to cathode spacing is maintained.

NOTE: During plating a test strip is exposed to a uniform current density along the legs of the strip.  The plating test should be continued until the test strip legs deflect up to 20 units and with a target thickness that does not exceed approximately 100 microinches for the most accurate results.  Very low stress may show only 1-2 units.

*NOTE: This cell is not to be used with Chrome solutions.

Plating Cell Features:

  • Made of Poly-carbonate (which is NOT recommended for Chrome plating)
  • Is a self contained unit for Lab work
  • Two anode pockets for 2 3/8″ (61 mm) x 2 3/8″ (61 mm) size anodes
  • Leads to each anode from a central contact
  • Is a divided Cell with two compartments with flow holes between the compartments (one for PN:  3046 Immersion Heater and PN:  404 Submersible Pump, and the other one for plating the test strip)
  • PN: 404 Submersible Pump is included with the purchase of a PN:  800L Plating Cell
  • A clip assembly for positioning the test strip midway between the anodes

Additional information

Weight 7 lbs
Dimensions 9 × 8 × 7 in